Tank Bottom Savers |
 |
Corrosion Control and Environmental Protection for Your Tank!
With the high cost of tanks, it makes sense to spend a few more dollars to protect your investment. The Bottom Saver stops corrosion by breaking the electric currents needed for corrosion to take place. You also get the piece of mind that a pinhole leak in the tank cannot go undetected. The built-in sump (optional) allows you to clean the tank without putting fluids on the ground. The Bottom Saver is fully reusable and guaranteed for the life of the tank against chemical and ultraviolet attack.
The Bottom Saver is a High Density Polyethylene (HDPE) tank pad specially designed to do six things:
-
Remove corrosion-causing moisture from the tank bottom
-
Extends the life of new and used tanks
-
Create absolute assurance that no pinhole leaks are seeping into the ground
-
Keep bottom sediments off the ground during routine tank cleaning
-
Protects the earth under the tank
-
Be affordable .
Installation
Unroll the Bottom Saver and place in the desired location. Then dig a small hole for the sump (sump optional). Place the tank on the Bottom Saver, positioning the clean-out manway in the sump. The tank can be slid into proper alignment without damaging the Bottom Saver as long as the clean-out manway remains in the sump. Two men can install a Bottom Saver in about 10 minutes.
The Bottom Saver can be expanded into a complete secondary containment lining system. This can be done at any time, even years later without lifting the tank.
In today's world, can you afford not to protect your tank bottom and the earth under it?
Phone: 1-888-PIT-LINE
Available 24/7:
Cell: (405) 255-0806
Cell: (405) 820-5363
Fax: (405) 275-4625
E-mail: oilfield@unitliner.com
|
